双组份打胶机在使用中会出现怎样的问题？
双组份打胶机的使用效率高且效果好，但是使用时间长了或者其他原因导致的，问题时有发生，下面小编讲解四个常见的问题。
The two-component sealant dispenser is efficient and effective, but problems often occur due to a long time of use or other reasons. Here are four common problems.
1.胶水流体内产生气泡：在全自动打胶机使用期间，过大的流体压力再外部打开点胶阀时，可能将空气渗入胶水中，从而产生了气泡。
1. Bubbles are generated in the glue fluid: during the use of the full-automatic glue dispenser, when the dispensing valve is opened externally under excessive fluid pressure, air may seep into the glue, resulting in bubbles.
2.自动打胶机使用时出现漏胶：点胶阀在使用完毕后正常关闭，出现胶水渗漏，这是因为配置的针头太小，影响液体的流动造成背压。
2. Glue leakage occurs when the automatic glue dispenser is used: the glue dispensing valve is normally closed after use, and glue leakage occurs, because the configured needle is too small, affecting the flow of liquid and causing back pressure.
3.全自动打胶机流速太慢：胶水流速若太慢主要是胶管过窄或者过长，当然还要注意出胶口和气压是不是处于正常情况。
3. The flow rate of the full-automatic glue dispenser is too slow: if the glue flow rate is too slow, it is mainly because the rubber hose is too narrow or too long. Of course, pay attention to whether the glue outlet and air pressure are normal.
4.平台打胶机设备出胶量大小不一致：出胶量大小不一致的情况主要是储存胶水流体的压力筒还有机器配置空气压力不稳定所产生。
4. The glue output of the platform glue dispenser is inconsistent: the inconsistent glue output is mainly caused by the unstable pressure of the pressure cylinder for storing glue fluid and the air pressure configured for the machine.
What problems will occur in the use of two-component glue dispenser? Four problems have been mentioned. In fact, there are many types of problems that need to be prevented in advance. Follow us http://www.jntiannuo.com Learn more!
上一篇：打胶机组成部分的五点保养事项
下一篇：双组份打胶机的日常使用注意事项
