带你了解一下关于双组份点胶机注意事项
双组份点胶机注意事项:
Precautions for two-component dispensing machine:
1.由于双组份密封胶的固化需要一定的时间，所以在双组份打胶机上涂有双组份密封胶的玻璃要水平移动。
1. Since the curing of two-component sealant takes a certain time, the glass coated with two-component sealant on the two-component gluing machine shall move horizontally.
2.A组和B组胶水应保持清洁，防止异物进入胶水。
2. Group A and group B glues shall be kept clean to prevent foreign matters from entering the glue.
3.在连续工作过程中，胶枪每次停止工作一般不应超过20分钟，否则用A组份胶将混合的胶全部冲出，直到从枪口排出一根A组份胶为止。
3. During continuous operation, the glue gun shall not stop working for more than 20 minutes each time, otherwise all the mixed glue shall be washed out with component a glue until a component a glue is discharged from the muzzle.
4.严禁强行挤压或弯曲高压软管，以免影响系统的正常运行。
4. It is forbidden to forcibly squeeze or bend the high-pressure hose to avoid affecting the normal operation of the system.
5.混胶机应始终保持通畅，以保证良好的出胶效果。如有堵塞，可在丙酮中浸泡后清洗。建议每5组清洗一次。
5. The mixer shall always be kept unobstructed to ensure good glue output effect. If it is blocked, it can be soaked in acetone and cleaned. It is recommended to clean every 5 groups.
6.当胶枪长时间不使用(超过一周)时，应将胶枪本体拆下，用溶剂清洗胶枪和混胶机内的残余胶。
6. When the glue gun is not used for a long time (more than one week), remove the glue gun body and clean the residual glue in the glue gun and mixer with solvent.
7.不同的双组份胶水厂家生产的胶水中杂质的量是不同的。根据实际情况，b组过滤器和单向止回阀通畅。建议每两组清洗一次。
7. The amount of impurities in the glue produced by different two-component glue manufacturers is different. According to the actual situation, group B filter and one-way check valve are unobstructed. It is recommended to clean every two groups.
The wonderful content of this article is provided by Jinan two-component gluing machine. There are many wonderful contents on this website. You can click to enter more contents: http://www.jntiannuo.com We have special customer service to answer your questions
上一篇：双组份打胶机保养的注意事项
下一篇：有双组份打胶机的工作原理和适用使用范围
