双组份打胶机的注意事项
由于双组份密封胶的固化需要一定时间，因此，已涂了双组份密封胶的玻璃应水平轻轻搬动。
Since the curing of two-component sealant takes a certain time, the glass coated with two-component sealant shall be moved horizontally and gently.
组、b组份胶应保持清洁，严防异物进入胶中。
The glue of components a and B shall be kept clean to prevent foreign matters from entering the glue.
在连续工作过程中，胶枪每次停止工作时间一般不得超过20分钟，否则 中空双组份打胶机，应用a组份胶冲出全部混合胶，直单一的a组份胶从枪口排出为止。
In the process of continuous operation, the stopping time of the glue gun shall not exceed 20 minutes each time. Otherwise, the hollow two-component glue applicator shall use component a glue to punch out all the mixed glue until a single component a glue is discharged from the muzzle of the gun.
高压胶管不得---挤压、弯曲，防止影响系统正常工作。
The high-pressure rubber hose shall not be --- squeezed or bent to prevent affecting the normal operation of the system.
混胶器应经常保持通畅，以良好的出胶效果。如遇堵塞情况，可用---浸泡后清洗。建议每5组清洗一次。
The mixer shall be kept unobstructed frequently to achieve good glue output effect. In case of blockage, it can be cleaned after soaking. It is recommended to clean every 5 groups.
当胶枪长时间不用时（超过一周），应拆下枪体使用溶剂将胶枪和混胶器内的残留胶体清洗干净。
When the glue gun is not used for a long time (more than one week), remove the gun body and clean the residual colloid in the glue gun and mixer with solvent.
不同双组份胶生产厂家所生产的胶内含杂质数量不同，根据实际情况清晰b组分的过滤网及单向止回阀 双组份打胶机胶枪，建议每两组清洗一次。
The amount of impurities in the glue produced by different two-component glue manufacturers is different. According to the actual situation, the filter screen of component B and the glue gun of one-way check valve two-component glue applicator are clear. It is recommended to clean every two groups.
任何因胶体固化所造成的胶枪、管路或整机的故障 双组份打胶机配件，一律不在保修范围之内。
Any failure of glue gun, pipeline or the whole machine caused by colloid solidification, and the accessories of two-component glue applicator are not within the scope of warranty.
定期给各泵的加油口加油，应油雾器内不断油。
Fill the oil filler of each pump regularly, and keep oil in the oil mist.
上一篇：打胶机跟灌胶机的区别
下一篇：双组份打胶机怎么更换打胶机通？
