济南双组份打胶机日常如何进行维护？
1.由于
济南双组份打胶机密封胶的固化需要一定时间,因此,已涂了双组份打胶机密封胶的玻璃应水平轻轻搬动.
1. As the curing time of Jinan two-component sealant is required, the glass coated with two-component sealant should be moved horizontally and gently
2.双组份打胶机的A组、B组份胶应保持清洁,严防异物进入胶中.
2. The A and B components of the two-component gluing machine should be kept clean to prevent foreign matters from entering the glue
3.在连续工作过程中,胶枪每次停止工作时间一般不得超过20分钟,否则,应用A组份胶冲出全部混合胶,直单一的A组份胶从枪口排出为止.
3. In the process of continuous operation, the stop time of glue gun should not exceed 20 minutes each time. Otherwise, all the mixed glue should be flushed out with component a until the single component a glue is discharged from the muzzle
4.双组份打胶机的高压胶管不得强行挤压、弯曲,防止影响系统正常工作.
4. The high pressure hose of the two-component gluing machine shall not be forced to squeeze or bend to prevent the normal operation of the system
5.混胶器应经常保持畅通,以保证良好的出胶效果.如遇堵塞情况,可用丙酮浸泡后清洗.建议每5组清洗一次.
5. The mixer should always be kept smooth to ensure good glue output. In case of blockage, it can be cleaned after soaking in acetone. It is recommended to clean every 5 groups
6.当的胶枪长时间不用时(超过一周),应拆下枪体使用溶剂将胶枪和混胶器内的残留胶体清洗干净.
6. When the glue gun is not used for a long time (more than a week), the gun body should be removed and the residual colloid in the glue gun and mixer should be cleaned with solvent
7.不同双组份胶生产厂家所生产的胶内含杂质数量不同,根据实际情况清晰B组分的过滤网及单向止回阀,建议每两组清洗一次
7. The amount of impurities in the rubber produced by different two-component rubber manufacturers is different. According to the actual situation, the filter screen and one-way check valve of component B should be clear. It is recommended to clean every two groups
8.定期给各泵的加油口加油,应保证油雾器内不断油.
8. Add oil to the oil filler of each pump regularly, and ensure that there is no oil in the atomizer
了解了
济南双组份打胶机的日常维护要点后,相信您也懂得了应该怎么来维护您的双组份打胶机了吧.
After understanding the daily maintenance points of Jinan two-component gluing machine, I believe you also know how to maintain your two-component glue machine
上一篇：选用济南双份打胶机需要考虑哪些问题?
下一篇：济南双组份打胶机是如何解决漏气现象的？
