双组份打胶机的操作流程
双组份打胶机的操作过程十分的简单,小编大概总结下分为两个部分一个是控制系统的操作,另一个就是胶桶的安装/更换,具体点的方法如下。
The operation process of the double component glue machine is very simple. It is divided into two parts, one is the operation of the control system, the other is the installation / replacement of the buckets, and the specific point is as follows.
1.接通电源(380V 三相四线)和气源(0.6-0.7MPa)。
1. connect the power supply (380V three-phase four lines) and gas source (0.6-0.7MPa).
2.打开A,B胶供胶阀门,关闭B胶回流阀门。
2. open A, B glue for glue valve, close B glue return valve.
3.在控制面板上选择“开机”然后检查一下A,B胶是否工作正常。此时供胶机混胶工作准备就绪。
3. select the "boot" on the control panel and check if the A B glue is working properly. The glue mixing machine is ready at this time.
4、如果长时间不用(超过15分钟)或者是下班时要在控制面板上选择“冲枪”,然后打开B胶回流阀门,关闭B胶供胶阀门.此时供胶机冲枪准备工作就绪。
4. If you do not use (more than 15 minutes) for a long time or at the end of the day, select the "gun" on the control panel, then open the B glue reflux valve and turn off the B glue valve.
5、每次操作前确保设备的水平度,调整机器的水平度,调节地脚的高度使机身水平。
5, ensure the level of equipment before each operation, adjust the level of the machine, adjust the height of the foot to make the fuselage level.
6、接通电源后先检查各电机的旋转方向是否正确,接通与CL—A—01打胶机的胶管,信号。
6, after switching on the power supply, check whether the rotation direction of the motors is correct, and connect the hose with the CL - A - 01 gluing machine.
感谢大家在百忙之中关注公司发布的产品信息,如果你想要了解更多,可以来我们公司咨询。我们欢迎大家的光临,并与你的合作!
Thank you for your busy schedule to pay attention to the product information released by the company. If you want to know more, you can come to our company for consultation. We welcome your presence and cooperate with you!
上一篇:中空玻璃打胶机都有哪些作用呢
下一篇:双组份打胶机的操作你了解吗?