一般情况下,能够正确的使用机器，一方面能够做好产品，另一方面也可以延长机器的使用寿命，保持机器的性能稳定持久。使用双组份打胶机也是如此，下面简单的说明一下，主要有以下几点：

In general, if you can use the machine correctly, on the one hand, you can do a good job of the product, on the other hand, you can extend the service life of the machine and keep the performance of the machine stable and lasting. The same is true for the two-component sealant dispenser. The following is a brief description, mainly including the following points:

1、使用机器前，确保电源电压的稳定以及电路，保证机器在开机中正常运行。

1. Before using the machine, ensure the stability of the power supply voltage and the safety of the circuit, and ensure the normal operation of the machine during startup.

2、确保机器的各工件都处入原点位置，机器上没有杂物，以免阻挡机器运行，

2. Make sure that all the workpieces of the machine are at the original position, and there are no sundries on the machine, so as not to block the operation of the machine,

3、经常给机器的滑轮处加黄油，保证门窗打胶机的滑轮润滑，运转时更流畅，

3. Add grease to the pulley of the machine frequently to ensure that the pulley of the door and window gluing machine is lubricated and runs more smoothly,

4、机器正在工作时，看看周围的人是否在的距离，以免机器在工作时伤害到旁边的人。

4. When the machine is working, check whether the people around are at a safe distance to prevent the machine from harming the people around.

5、开机前请先关闭总电源开关，再接通控制开关（on）；

5. Please turn off the main power switch before starting the machine, and then turn on the control switch (on);

6、按启动按钮，待电机转动后即可进行作业。如遇紧急情况时请立即按下停止键停机；

6. Press the start button to start the operation after the motor rotates. In case of emergency, please immediately press the stop button to stop the machine;

7、工作过程中如发现异常现象应立即关机切断总开关电源、拔出插头或更换相应保险丝后再重新开机运行操作.

7. In case of any abnormal phenomenon during operation, shut down the power supply of the main switch immediately, pull out the plug or replace the corresponding fuse, and then restart the machine for operation

在工作中应随时注意观察电机的运转状况是否正常、有无异响等异常现象发生。如有故障出现时应立即停机处理以免造成人身伤害和设备损坏。更多相关事项就来我们网站http://www.jntiannuo.com咨询了解吧！

During the operation, pay attention to whether the motor operates normally and whether there is abnormal noise and other abnormal phenomena. In case of any fault, stop the machine immediately to avoid personal injury and equipment damage. Come to our website for more information http://www.jntiannuo.com Ask and understand!