打胶机在打胶中发生断胶解决小妙招
在使用中空玻璃自动打胶机打胶时,在打胶过程中比较容易会发生断胶或者直接堵塞的现象。可能是由于硅酮胶不符合行业产品质量标准,杂质过多导致堵塞。尽量使用符合行业标准的合格产品。就可以解决这类情况。
When the insulating glass automatic gluing machine is used for gluing, it is easy to break the glue or block it directly during the gluing process. It may be that the silicone glue does not meet the quality standards of the industry products, and there are too many impurities leading to blockage. Try to use qualified products that meet national industrial standards. This kind of situation can be solved.
打胶机在打胶中发生不出胶解决小妙招
The glue applicator fails to produce glue in the process of gluing. Tips for solving the problem
1、看看打胶机的气源是否在0.6~0.8Mpa之间。
1. Check whether the air source of the glue applicator is between 0.6 and 0.8MPa.
2、检查黑白胶开关与电磁阀是否有正常运作。
2. Check whether the black-and-white glue switch and solenoid valve operate normally.
3、检查液压站有没有压力,如果没有压力,也会导致不出胶的情况。
3. Check whether there is pressure in the hydraulic station. If there is no pressure, it will also lead to glue failure.
4、检查屏显示的编辑功能菜单中的密封不使用是否打开。
4. Check whether the seal in the edit function menu displayed on the screen is turned on when it is not in use.
5、检查清洗时能否出白胶,如果不出白胶,检查313胶管、旋转接头是否有阻塞。
5. Check whether there is white glue during cleaning. If there is no white glue, check whether 313 rubber hose and swivel joint are blocked.
Jinan two-component glue applicator has flower glue in the process of gluing, which is a clever way to solve the problem
1、看看黑胶、白胶压力是否是保持平衡:黑胶胶泵压力不能低于0.6Mpa、白胶胶泵压力大概为0.4Mpa左右。
1. Check whether the pressure of black glue and white glue is balanced: the pressure of black glue pump cannot be lower than 0.6MPa, and the pressure of white glue pump is about 0.4MPa.
2、检查一下黑胶、白胶的比例配比是否为1:10左右。
2. Check whether the proportion of black glue and white glue is about 1:10.
3、检查看看混胶器是否安装正确以及是否被及时清理。
3. Check whether the glue mixer is installed correctly and cleaned in time.
4、看看黑胶、白胶的智能压力表的参数是否正常。
4. Check whether the parameters of the intelligent pressure gauge of black glue and white glue are normal.
In order to ensure the quality of products in the future, it is necessary to carry out maintenance in normal times and do maintenance work in advance. For more information, please come to the website http://www.jntiannuo.com Consult.
上一篇:讲解打胶机的安装调试过程
下一篇:点胶机操作流程以及维护保养事项