混胶机控制出胶量的有效方式

济南双组份打胶机在更换胶管时，注意不要把空气引入到胶体通道中。如果胶管中有空气残留，而你又确定空气没有通过胶管进入灌胶泵中。针对灌胶系统：排胶要有足够时间，使新胶管中的胶体顺利流出灌胶头，确认灌胶阀的压力和速度按照理想状态设定。然后测定胶体流速，直连续两次测量结果的误差在正负 2% 范围以内。
When replacing rubber hoses, the two component glue machine in Ji'nan is careful not to introduce air into colloidal passages. If there is any residual air in the hose, you will make sure that the air does not pass through the hose into the filling pump. For the glue system: the glue should have enough time to make the colloid in the new rubber tube out of the glue head smoothly and confirm the pressure and speed of the filling valve according to the ideal condition. Then the flow rate of colloid was measured until the error of two successive measurements was within the range of positive and negative 2%.

1、利用体积来控制，也就是活塞，体积到了一定的程度，活塞自动切断进料。
1, the volume control, that is, the piston, to a certain extent, the volume of the piston automatically cut off feed.
2、利用点胶控制器，只要我们对高精密的点胶阀进行控制，就可以达到点胶机出胶量的大小。
2, using glue dispenser, as long as we control the high-precision dispensing valve, we can achieve the size of dispensing machine.
3、出胶压力，压力的大小我们可以通过调节调压阀来控制压力的大小，只要气源的压力稳定，那么出胶的压力自然也就稳定了。
3, out of the pressure, the size of the pressure we can adjust the pressure valve to control the size of the pressure, as long as the pressure of the gas source is stable, then the pressure of the glue is naturally stable.
4、通过控制出胶时间，如果出胶时间设置的越长，那么出胶量就越大，反之，则越小。
4, by controlling the gel time, the longer the dispensing time is, the larger the amount of gel will be, and the smaller it will be.
以上的介绍，您了解了吗？如果您有不明白的地方，欢迎您的致电，我们为您介绍，欢迎您的莅临参观哦。
Do you know the above introduction? If you do not understand, please call us. We will introduce you to you. Welcome to visit us.

上一篇：双组份打胶机的安装方法
下一篇：发泡机设备是如何工作的？