双组份打胶机的安装方法

1、双组份打胶机设备应安装在干燥、无粉尘、无腐蚀性气体的坏境中，如果条件达不到少争取无腐蚀性气体，毕竟设备中有电线以及管路这些配件抗腐蚀性不高。
1, the double component glue machine equipment should be installed in the dry, dust free, non corrosive gas, if the conditions are not reached at least for the non corrosive gas, after all, the equipment with wires and pipelines are not corrosion-resistant.
2、室内温度好控制在10～40度的室内坚硬地面上，地面应水平度要好。在设计之初已经考虑到了地面复杂性的因素所以对地面平整度是有相当大的忍让度的，只要不是幅度提别的大一般都可以正常工作。
2, indoor temperature is best controlled in 10~40 degree indoor hard ground, the ground should be better. At the beginning of the design, the complexity of the ground has been taken into account so that the ground flatness is quite tolerable, as long as it is not large enough to work normally.

3、双组份打胶机安装之前，应先检查是否有因运输、搬动造成的变形、损坏和紧固件松动情况，之前就曾经有客户在移动打胶机的过程中把设备的智能控制系统的一个零部件碰掉了而导致设备无法正常运行。
3, before the installation of the double component glue machine, we should first check whether there is the deformation, damage and loosening of the fastener due to transportation and moving, before the customer has touched off one component of the intelligent control system of the equipment in the process of moving the glue machine, which causes the equipment to be unable to run normally.
4、我们可以根据地面平整度的实际情况来通过调整设备的可升降地脚螺栓来调整设备的水平度直到设备水平而稳固。然后按图接线并可靠接地，把气源接入机器所配带的气源接口，确保无漏气现象。
4. First, we can adjust the level of the equipment to the level of the equipment to the level of the equipment, according to the actual condition of the ground flatness. Then according to the diagram connection and reliable grounding, the air source is connected to the air source interface provided by the machine to ensure that there is no air leakage.
5、向油槽中加注液压油指定位置。
5, fill the oil tank with hydraulic oil to the specified position.
感谢大家在百忙之中关注公司发布的产品信息，如果你想要了解更多，可以来我们公司咨询。我们欢迎大家的光临，并与你的合作！
Thank you for your busy schedule to pay attention to the product information released by the company. If you want to know more, you can come to our company for consultation. We welcome your presence and cooperate with you!

上一篇：双组份打胶机的性能特点
下一篇：混胶机控制出胶量的有效方式