详解双组份打胶机比例泵密封圈
1.双组份打胶机因为中空玻璃打胶机密封胶的固化需要必定时间，因此 双组份打胶机，已涂了双组份密封胶的玻璃应水平轻轻搬动。
1. Two component gluing machine because the gluing of insulating glass and the curing of sealing glue need a certain time, so the glass coated with two-component sealant should be moved horizontally and gently.
2.A组、B组份胶应保持清洁，谨防异物进入胶中。
2. The glue of group A and B shall be kept clean to prevent foreign matters from entering the glue.
3. 双组份打胶机在连续作业过程中，胶枪每次停止作业时间一般不得超过20分钟，不然，应用A组份胶冲出全部混合胶，直单一的A组份胶从枪口排出停止。
3. During the continuous operation of the two-component glue applicator, the operation time of the glue gun shall not exceed 20 minutes each time. Otherwise, all the mixed glue shall be washed out with component a glue until a single component a glue is discharged from the muzzle.
4.双组份打胶机高压胶管不得强行揉捏、弯曲，防止影响系统正常作业。
4. The high-pressure hose of the two-component gluer shall not be kneaded or bent forcibly to prevent affecting the normal operation of the system.
5.混胶器应经常保持通畅，以确保良好的出胶作用。如遇堵塞情况，可用丙酮浸泡后清洗。主张每5组清洗一次。
5. The mixer shall be kept unobstructed frequently to ensure good glue delivery. In case of blockage, it can be soaked in acetone and cleaned. It is recommended to clean every 5 groups.
6.当胶枪长期不用时(超过一周)，应拆下枪体运用溶剂将胶枪和混胶器内的残留胶体清洗干净。
6. When the glue gun is not used for a long time (more than one week), remove the gun body and clean the residual colloid in the glue gun and mixer with solvent.
7.不同中空玻璃打胶机出产厂家所出产的胶内含杂质数量不同，依据实际情况明晰B组分的过滤网及单向止回阀，主张每两组清洗一次。
7. The quantity of impurities in the glue produced by different manufacturers of insulating glass gluing machine is different. The filter screen and one-way check valve of component B shall be clarified according to the actual situation, and it is advocated to clean every two groups.
8.任何因胶体固化所形成的胶枪、管路或整机的故障 双组份打胶机，一概不在保修范围之内。
8. Any failure of glue gun, pipeline or the whole machine caused by colloid solidification. The cost of two-component glue applicator is not within the scope of warranty.
9.定期给双组份打胶机各泵的加油口加油中空玻璃打胶机，应确保油雾器内不断油。
9. Regularly add oil to the oil filler of each pump of the two-component glue applicator. The insulating glass glue applicator should ensure that there is continuous oil in the oil mist.
The above is the knowledge brought to you today. Jinan two-component gluing has focused on the industry for many years and continuously provided users with valuable content. Please continue to pay attention to us for more content: http://www.jntiannuo.com
上一篇：什么情况下会导致打胶机打胶不均匀？
下一篇：自动打胶机的特点有哪些？
