The problem of insufficient gluing of insulating glass gluing machine is mainly caused by the following two situations!

一、打胶速度过快导致的

1、 It is caused by too fast gluing speed

有的客户为了自己的生产节奏追赶生产计划，将打胶速度认为调整的过快，导致胶体还没有完全达到合格标准机头就已经移动到下一个位置进行打胶操作了，如果需要打胶的速度调整了打胶机的移动参数的话，那么对应的也应该对供胶系统也进行相应的设置，比如这时候我们就需要加大供胶压力，加大打胶机的出胶速度来配合对象的移动速度的增加。如果我们仅仅是单独的增加了打胶机的移动速度而没有对压力进行调节的话就很有可能出现打胶不饱满的情况发生。

In order to catch up with the production plan for their own production rhythm, some customers think that the glue application speed is adjusted too fast, resulting in that the glue has not fully reached the qualified standard, and the machine head has moved to the next position for glue application. If the glue application speed needs to adjust the moving parameters of the glue application machine, the corresponding glue supply system should also be set accordingly, For example, at this time, we need to increase the glue supply pressure and increase the glue output speed of the glue applicator to match the increase of the moving speed of the object. If we only increase the moving speed of the gluing machine without adjusting the pressure, it is likely that the gluing is not full.

二、供胶压力不足

2、 Insufficient glue supply pressure

即便没有对打胶机的移动速度进行调节也出现了打胶不饱满的情况，那么也有可能是供胶压力过小导致的。这时候仅仅需要调整供胶压力即可很好的解决这个问题的发生。

Even if the moving speed of the gluing machine is not adjusted, the gluing is not full, which may be caused by too small glue supply pressure. At this time, we only need to adjust the glue supply pressure to solve this problem.

三、机头感应器损坏

3、 Head sensor damaged

这种情况非常的少见，但是也不排除这种情况的发生。打胶机机头有一个对铝条深浅进行探测的感应器，如果发现铝条过深或者过浅的时候他会自动的调整移动的移动速度以及供胶压力（自动调整幅度是小范围内的）。

This situation is very rare, but it does not rule out the occurrence of this situation. There is a sensor at the head of the glue applicator to detect the depth of the aluminum strip. If it is found that the aluminum strip is too deep or too shallow, it will automatically adjust the moving speed and glue supply pressure (the automatic adjustment range is within a small range).