The maintenance of insulating glass production line in use is very simple, mainly to maintain the lubrication of all aspects of the pulley, maintain the stability of the voltage, prevent the burning of electrical appliances and so on, which should be paid attention to in the maintenance of insulating glass production line.

为保证机器的良好运行，应加强中空玻璃生产线的日常维护与保养，中空玻璃生产线在运行中若有异常情况应立即停车检查，排除故障后再重新启动。

In order to ensure the good operation of the machine, the daily maintenance of the insulating glass production line should be strengthened. If there is any abnormal situation in the operation of the insulating glass production line, the machine should be stopped immediately for inspection, and the machine should be restarted after troubleshooting.

中空玻璃生产线出现较大的的故障时应有人士来维修，在开始检修前切忌关掉总电源。

When there is a big fault in the insulating glass production line, it should be repaired by someone. Do not turn off the main power before maintenance.

1、传动维护：各传送辊轴承、毛刷辊轴承、传送轴承、链轮、齿轮定期加注钙基润滑脂；微型摆线针轮减速机每半年加钙基润滑脂一次；无级调速器每半年换Ub—l或Ub—3型润滑油一次，且在运转过程中应时常检查其油位，保持油位在滑标线以上；

1. Transmission maintenance: the transmission roller bearing, brush roller bearing, transmission bearing, chain wheel and gear shall be regularly filled with calcium grease; the micro cycloid pin gear reducer shall be filled with calcium grease once every half a year; the stepless speed governor shall be replaced with ub-l or ub-3 lubricating oil once every half a year, and the oil level shall be checked frequently during the operation to keep the oil level above the center line of the slide mark;

2、水路维护：水箱内循环水应每天更换，水箱每周清洗一次，经常检查喷水嘴喷水情况，若发现堵塞应及时清理。

2. Waterway maintenance: the circulating water in the water tank should be replaced every day, and the water tank should be cleaned once a week. The water spraying condition of the water nozzle should be checked frequently, and the blockage should be cleared in time.

3、风路维护：定期检查风机运行情况，如有异常声音应立即停机检查，定期清洗风机过滤栅，减小引风阻力，提高风干后玻璃表面洁净度。

3. Air path maintenance: regularly check the operation of the fan, if there is any abnormal sound, stop the machine immediately for inspection, regularly clean the filter grid of the fan, reduce the induced draft resistance, and improve the cleanliness of the glass surface after air drying.