全自动涂胶机在涂胶时出现问题的原因！
全自动涂胶机在涂胶时出现混合搅拌器无法旋转的原因以及具体的解决方法。以下几个方面是上根据长期的涂胶经验，总结出的几项导致混合搅拌器无法正常旋转的原因：
The reason why the mixer can't rotate in the automatic gluing machine and the specific solution are presented. The following aspects are the reasons why Shanghai Shanjia can't rotate the mixer properly according to its long-term experience in gluing.
1、混合电机220V电源未开。
1. The 220V power supply of the hybrid motor is not turned on.
2、混合电机线路有损坏或松动。
2. Hybrid motor lines are damaged or loosened.
3、搅拌器或轴承有卡死
3. Stirrer or bearing stuck
4、伺服驱动器菜单未在显示PC模式。
4. Servo driver menu is not showing PC mode.
具体的解决方法：
Specific solutions:
1、打开混合电机驱动器的220V电源开关
1. Turn on 220V power switch of hybrid motor driver
2、检查混合电机的线路，插好混合电机的电源前后端接口
2. Check the circuit of the hybrid motor and plug in the front-end and back-end interface of the hybrid motor.
3、检查混合室是否干净，混合枪轴承有损坏需要更换
3. Check whether the mixing chamber is clean or not. If the bearing of the mixing gun is damaged, it needs to be replaced.
4、关掉电源重新启动机械（重启后还未显示PC模式检查电机线路接头前段和后端和控制系统的那端
4. Turn off the power supply and restart the machine (PC mode is not displayed after restart to check the front and back end of the motor line connection and the end of the control system).
上一篇：密封胶对于打胶机的重要性！
下一篇：自动打胶机不为人知的小功用！
