一般情况下，要能够正确使用打胶机，一方面可以做出好的产品，另一方面也可以延长打胶机的使用寿命，保持打胶机的性能稳定持久，下面双组份打胶机厂家为您简单说明一下。

In general, you should be able to use the glue dispenser correctly. On the one hand, you can make good products, on the other hand, you can extend the service life of the glue dispenser, and keep the performance of the glue dispenser stable and lasting. The two-component glue dispenser manufacturer will give you a brief explanation.

1.由于双组份密封胶的固化需要一定的时间，已涂覆双组份密封胶的玻璃应缓慢水平移动。

1. As the curing of two-component sealant requires a certain time, the glass coated with two-component sealant shall slowly move horizontally.

2.A组和B组胶水应保持清洁，防止异物进入胶水。

2. Group A and Group B glue shall be kept clean to prevent foreign matters from entering the glue.

3.在连续工作过程中，胶枪每次停止工作一般不应超过20分钟，否则用A组份胶将混合的胶全部冲出，直到从枪口排出一根A组份胶为止。

3. In the process of continuous operation, the glue gun shall not be stopped for more than 20 minutes each time, or the mixed glue shall be flushed out with component A glue until a component A glue is discharged from the gun mouth.

4.严禁强行挤压或弯曲高压软管，以免影响系统的正常运行。

4. It is forbidden to forcibly squeeze or bend the high-pressure hose to avoid affecting the normal operation of the system.

5.混胶机应始终保持畅通，以保证良好的出胶效果。如有堵塞，可在丙酮中浸泡后清洗。建议每5组清洗一次。

5. The glue mixer shall always be kept unblocked to ensure good glue discharging effect. If there is blockage, it can be cleaned after soaking in acetone. It is recommended to wash every 5 groups.

6.当胶枪长时间不使用(超过一周)时，应将胶枪本体拆下，用溶剂清洗胶枪和混胶机内的残余胶。

6. When the glue gun is not used for a long time (more than a week), the glue gun body should be removed, and the residual glue in the glue gun and the glue mixer should be cleaned with solvent.

7.不同的双组份胶水厂家生产的胶水中杂质的量是不同的。根据实际情况，b组过滤器和单向止回阀通畅。建议每两组清洗一次。

7. The amount of impurities in the glue produced by different two-component glue manufacturers is different. According to the actual situation, group b filters and one-way check valves are smooth. It is recommended to wash every two groups.

8.因胶水凝固而引起的胶枪、管道或整机故障，不保修。

8. There is no warranty for the failure of glue gun, pipe or complete machine caused by the solidification of glue.

9.定期对各油泵加油口进行加油，确保注油器中有连续的油。

9. Fill the oil filler of each oil pump regularly to ensure that there is continuous oil in the oil injector.

此外使用打胶机前，确保电源电压稳定，电路，确保机器开机时正常运行。打胶机工作时，检查周围的人是否保持距离，以免机器工作时伤及附近的人。关注我们http://www.jntiannuo.com，了解更多事项！

In addition, before using the glue applicator, ensure that the power supply voltage is stable, the circuit is safe, and the machine can operate normally when it is started. When the glue applicator is working, check whether the people around it keep a safe distance to avoid injuring the people nearby when the machine is working. Follow us http://www.jntiannuo.com , learn more!