1. The equipment of two-component glue applicator shall be installed in a dry, dust-free and corrosive gas free environment. This requirement is consistent with other equipment. Of course, if the conditions are not met, at least strive for no corrosive gas. After all, the corrosion resistance of wires and pipelines in the equipment is not high.

2、室内温度好控制在10～40度的室内坚固地上上，地上应水平度要好。

2. The indoor temperature shall be well controlled, and the indoor solid ground with a temperature of 10 ~ 40 degrees shall be better leveled on the ground.

3、双组份打胶机装置之前，应先检查是否有因运输、搬动造成的变形、损坏和紧固件松动状况，之前就曾经有客户在移动打胶机的过程中把设备的智能控制系统的一个零部件碰掉了而导致设备无法正常运转，咱们的工作人员到现场后才排查出的原因。

3. Before installing the two-component glue applicator, we should first check whether there is deformation, damage and fastener looseness caused by transportation and moving. Before, a customer knocked off a part of the intelligent control system of the equipment in the process of moving the glue applicator, resulting in the failure of normal operation of the equipment. Our staff found out the reason after arriving at the site.

4、咱们可以依据地上平整度的实际状况来经过调整设备的可升降地脚螺栓来调整设备的水平度直到设备水平而稳固。然后按图接线并牢靠接地，把气源接入机器所配带的气源接口，保证无漏气现象。

4. First of all, we can adjust the levelness of the equipment by adjusting the lifting anchor bolts of the equipment according to the actual situation of ground flatness until the equipment is horizontal and stable. Then connect the wiring according to the diagram and firmly grounded, and connect the air source to the air source interface equipped with the machine to ensure no air leakage.

5、双组份打胶机向油槽中加注液压油指定位置，46#液压油。

5. The two-component glue applicator fills the oil tank with hydraulic oil to the specified position and 46# hydraulic oil.

6、接通电源并翻开查看设备是否能够正常运转。

6. Turn on the power and turn it on to see if the equipment can operate normally.