The insulating glass production line mainly has four sections: feeding section, cleaning and drying section, inspection section and closing section. With the continuous progress of technology, it is believed that the application of insulating glass will be more and more widely. Then, due to the high degree of automation and excellent quality of insulating glass production line, more and more customers will choose insulating glass production line. However, the insulating glass production line needs continuous maintenance, and many users may worry about how to maintain the insulating glass production line.

1.中空玻璃生产线的后背板需要有一定的倾斜度，这样才能保证传输玻璃时不会出现意外而碎片；

1. The back plate of the insulating glass production line needs to have a certain inclination, so as to ensure that there will be no accidental fragments during glass transmission;

2.中空玻璃生产线的车间要求清洁无灰尘，这样对中空玻璃生产线的电子元器件也是一种保护，另外，生产的中空玻璃内层也是无灰尘污染；

2. The workshop of the insulating glass production line is required to be clean and free of dust, which is also a kind of protection for the electronic components of the insulating glass production line. In addition, the inner layer of the insulating glass produced is also free of dust pollution;

3.中空玻璃生产线的清洗段对玻璃清洗时，使用去离子水，清洗玻璃更干净而且不留痕迹；

3. When cleaning the glass in the cleaning section of the insulating glass production line, deionized water is used to clean the glass and leave no trace;

4.中空玻璃生产线的链条和电机，需要增加润滑油或润滑脂的，需要定时检查并更换，检查接电线是否良好等；

4. If the chains and motors of the insulating glass production line need to add lubricating oil or grease, they need to be checked and replaced regularly, and check whether the connecting wires are in good condition;

5.中空玻璃生产线的合片段是生产线重要的一个机械部分，出现碎片，需要搞清楚是一块玻璃就碎片，这样是吸盘损坏，需要将合片段大张开打开，更换吸盘或真空发生器，倘若是二块玻璃时碎片，调整中空玻璃的板压用力.

5. The closing segment of the insulating glass production line is an important mechanical part of the production line. If there are fragments, it is necessary to find out that one piece of glass is broken. In this case, the suction cup is damaged. It is necessary to open the closing segment and replace the suction cup or vacuum generator. If there are two pieces of glass, adjust the plate pressing force of the insulating glass