In the process of making hollow glass, it is very important to have a link. The structural glue is used to completely seal the two glass glasses. Because the artificial glue is slow and the seal is broken, a large number of hollow glass production needs hollow glass glue machine. The next one will take you to the debugging method of hollow glass glue machine

　　1,个开关泵的中空玻璃胶机、电源开关、控制开关、控制台根据手动按钮,然后在显示屏找到原点,点击辅助的起源集,然后单击设置原点,注意原点时设置为避免碰撞头部和辅助吸盘。设置后返回设置玻璃的厚度，输入后，点击设置进入。命令，如位置与当前位置值是一致的

　　1. The hollow glass glue machine, power switch, control switch and console of the first switch pump are set according to the manual button, then find the origin on the display screen, click the auxiliary origin set, and then click to set the origin. Note that the origin is set to avoid collision with the head and auxiliary suction cup. After setting, return to set the thickness of glass. After input, click set to enter. Command, such as position is consistent with current position value

　　2. 打开个胶桶按钮，按下工作选项拍胶开始，然后按下切割

　　2. Open the first rubber barrel button, press the work option to start tapping, and then press the cut button

　　3、如果需要调节胶机压力，可以点击屏幕返回寻找密封配方，显示当前的密封压力，如果每边都缺胶，那么可以增加压力，压力量大的胶，压力量小的胶。如果发现某边胶量不够，就会在密封公式中显示已封好，上封、下封、下封，开始将边胶封好，然后从上往下订单

　　3. If you need to adjust the pressure of the glue machine, you can click the screen to return to find the sealing formula and display the current sealing pressure. If each side is short of glue, you can increase the pressure. Glue with large pressure and glue with small pressure can be used. If it is found that there is not enough adhesive on one side, it will be shown in the sealing formula that it has been sealed. Seal up, seal down and seal down, start to seal up the adhesive on the side, and then order from top to bottom

　　4. 如果某边只有少量或大量的胶，稍微调整一下胶的扫描量，量大的胶量大，量少的胶量小

　　4. If there is only a small amount or a large amount of glue on one side, slightly adjust the scanning amount of glue. The large amount of glue is large, and the small amount of glue is small