国内的点胶设备的不足主要表现在哪些方面？
国内点胶机设备普遍存在哪些不足？
What are the shortcomings of dispensing machine in China?
1.点胶机的内部散热系统不是很好；
1. The internal cooling system of dispensing machine is not very good;
2.饮水机的机器经常有碰撞现象；
2. The machines of the water dispenser often collide;
3.液晶防黑，会出现乱码；
3. The liquid crystal is black proof, and there will be disorder code;
4.一段时间运行后，会出现点胶机设备的位置偏差；
4. After a period of operation, there will be position deviation of dispensing machine equipment;
5.静电处理不理想，分配器工作时会产生大量静电；
5. The electrostatic treatment is not ideal, and a large amount of static electricity will be generated when the distributor works;
6，特别是三轴点胶机，运行速度慢；
6, especially the three-axis dispensing machine, the running speed is slow;
7.点胶设备将在正常运行的情况下出现；
7. Dispensing equipment will appear under normal operation;
8.Table与小型分配器一起使用一段时间。 表的继电器将损坏，导致信号在输出处泄漏。
8. Table is used with small distributor for a period of time. The relay of the meter will be damaged, causing the signal to leak at the output.
9. CF卡程序不够稳定。 工业计算机经常烧坏。
9. The CF card program is not stable. Industrial computers often burn out.
10.点胶机的承载能力较弱；
10. The loading capacity of dispensing machine is weak;
11.驱动器板连接器的连接松动，很容易导致主板与驱动器板之间的接触不良。
11. The connector of the drive board is loose, which is easy to cause poor contact between the main board and the drive board.
以上是点胶机设备的一些缺陷，以确保点胶机机械设备的，稳定和精确的点胶。
The above are some defects of dispensing machine equipment in China to ensure the efficient, stable and accurate dispensing of dispensing machine machinery and equipment.
上一篇：点胶机运行过程中常存在哪些缺陷？
下一篇：双组份打胶机在企业中起什么作用？
