Hollow glass in the production process, there is a key link, is to use structural glue to completely seal two pieces of glass, because manual gluing is slow, sealing is not good, so a large number of production hollow glass need hollow glass gluing machine, the following will take you together to understand the hollow glass gluing machine debugging methods.

　　1、打开中空玻璃打胶机的气泵开关,电源总开关,控制台开关,在控制台按手动按钮,然后在显示屏上找到原点设定,点击辅助原点设定,然后点击头部原点设定,注意原点设定时避免头部和辅助吸盘碰撞.设定好之后返回设定玻璃厚度,输入完以后,点击设置进入.等命令位置和当前位置数值一致即可

　　1. First, turn on the air pump switch, the main power switch and the console switch of the hollow glass gluing machine, press the manual button on the console, then find the origin setting on the display screen, click on the auxiliary origin setting, then click on the origin setting of the head, pay attention to the origin setting to avoid collision between the head and the auxiliary sucker. After setting, return to the setting glass thickness, after input, click on the setting to enter. The position and the current position are identical.

　　2、打开桶胶按钮,按工作选择拍胶启动,在按伐开.此时胶头已经出胶,等看不见白胶,以混均匀以后按伐关,在按链接生产线,此时可以自动打胶.开始打胶要看每条边每个角打胶是否均匀

　　2. Open the first bucket of glue button, press the choice of work to start the glue tapping, and press the cutting. At this time, the glue head has been glued, so that no white glue can be seen, after mixing evenly, press the cutting off, in the link production line, at this time, you can automatically glue. Start gluing depends on whether each side and corner is even glued.

　　3、如果需要调整打胶机的压力,可以在屏幕上点击返回找到密封配方,会显示当前密封压力,如果每条边都缺胶,那么可增加压力,压力大胶量大,压力小胶量就小.如果发现某条边胶量不够时,在密封配方中会显示有向上密封,上部密封,向下密封,和下部密封,开始打胶的那条边就是向上密封,然后顺序从上

　　3. If you need to adjust the pressure of the glue beater, you can click back on the screen to find the sealing formula, which will show the current sealing pressure. If there is a lack of glue on each side, it will increase the pressure. If there is a large amount of glue on each side, the small amount of glue on the pressure will be small. The edge is sealed up, and then the order is from top to bottom.

　　4、如果发下只有某条边胶少或胶多时,调整扫描胶量细微调整,数值大胶量就大,数值小胶量就小.然后说下到末端伐关的距离,数值大,胶嘴到末端胶量少,数值小胶量大

　　4. If only one side glue is less or more, fine adjustment of scanning glue amount will result in a large amount of glue and a small amount of glue.